RLE Technologies announces the release of new firmware for the Falcon FMS facility monitoring appliance. Firmware version 8.6.16 includes several new enhancements to the Falcon’s new interactive mapping features. A full list of changes is below. Click here to download the new FMS firmware. List of changes to FMS firmware v8.6.16: 8.6.11A Added enumerated … Continued
Author: RLE Technologies
Falcon FMS firmware version 8.6.11 is now available. This update includes two important improvements to the FMS web interface: 1) User Configurable, Custom Interactive Maps Colors identify the alarm status Digital inputs displayed as squares Analog inputs displayed as values Modbus groups are displayed as circles (and link to the information from the group) 2) … Continued
As you install your leak detection system, we would like to highlight some of our accessories that can make your job easier and your leak detection system more effective. X-Connector X-Connector for easy cable branching (two end-of-line terminators are included) The X-Connector (X-CON) allows for branching of SeaHawk sensing cable and non-sensing cable. With one … Continued
What makes RLE Technologies’ patented SeaHawk Conductive Fluid Sensing Cable so special? It’s all in the mesh. An open problem Spot-leak detectors are a good solution for confined areas such as drip pans. But these detectors fall short when organizations must deal with an open area in which fluid flow is difficult to predict. RLE’s … Continued
RLE Technologies customers often want to use our SD-R01 spot detector to drive an external load, like an audible alarm or a pump. RLE does not currently have a leak detection product with a powered output. The SD-R01, like other RLE Technologies leak detection products, has a non-powered output: a Form C relay output. The … Continued
RLE® Technologies, based in Fort Collins, Colorado, announces the release of the SeaHawk™ LD2100. The LD2100 is an update to the SeaHawk™ LD2000 controller and expands on its existing technology by improving several capabilities and introducing advanced new features. The LD2100 is a distance-read leak detection controller designed to function as either a stand-alone device … Continued
Previously, we discussed how to secure SeaHawk leak detection cable, or sensing cable, to floors and other surfaces (see Securing SeaHawk Leak Detection Cable to Floors). Another important tip is to be careful when installing the cable near air conditioners. Condensation can cause false leak alarms. If the cable must be installed near an air … Continued
When AT&T began building its Internet services in the late 1990s, the company faced a dilemma. It needed to install uninterruptible power supplies (UPSs) in its facilities, but the devices wouldn’t interface with the existing network monitoring equipment in sites that were formerly SBC Internet sites. After some research, the company decided to make a … Continued
Are you installing SeaHawk leak detection cable (sensing cable) and looking to find the best way to keep the cable where you want it? Secure SeaHawk leak detection cable (sensing cable) to the floor with J-clips (RLE part number JC). J-clips are designed specifically for use with SeaHawk sensing cable. In addition, you can use … Continued
Falcon Facilities Monitoring Systems are designed to allow your team to monitor your facilities from anywhere through the product’s Web interface. However, VPN users do sometimes encounter a hitch. They may log in to the VPN, enter the Falcon’s IP address and see the authentication prompt — but never see a Web page. To correct … Continued